My large slide out awning bellows loose when in high winds while driving do slide out awnings have a lock so this won t happen appears now my fabric is ripped but don t want to replace till the problem is fixed.
Slide out awning loose.
Put a cotter pin in the hole.
Place the step stool near the lip.
The rivets shered and the bracket turned over and is resting on top of the slide.
Step up to the awning and clear out any leaves or twigs from the awning seam.
It is not uncommon for the fabric to become stretched out over time especially on the ends.
Really long toppers will have two.
The integrated wind deflector prevents billowing and provides fabric protection for when you travel.
Https amzn to 2paqqbu as an amazon associate i earn from qualifying purchases we show how to replace the rv slide out.
The first thing is to determine which topper you have and how many springs you have.
Many if not most slide toppers have only one spring which is probably the side that is tight.
No big deal and it will avoid too much tension.
When i extend my slide out and retract it the awning does go in tight but seems to unroll in high winds.
Remove end cap or mount.
Roller should now be free of mounting hardware.
We ve had a lot of wind here and tonight one of the slide awning brackets broke loose.
Our rv slide covers operate automatically with your slide out.
Park the rv and set the brake.
I can only reach up to the bracket location right now and it appears that the rivets are really small.
Dometic slide topper awnings come with a full case or a wind deflector and protects your slide seals from leaves and rainfall.
Look for the pin hole near end of roller.
The roller has a spring in it.
How to replace spring on awning slideout in rv adjust slide out cover how to tighten loose motorhome slideout covers tightening the spring on a slide out awning slide out kover ii how to adjust spring slide awning toppers tension adjustment how to tighten a carefree slideout topper how tochange the tension on a carefree of colorado.
I ll have to get a longer ladder tomorrow to get up there and see if i can repair it.
Just has an unpleasant experiance.
Run slide in about 12.
Roll up topper on roller.
Level the rig using its jacks and level system.
Just snap the support arm back into it s bracket and slide the tension arm into it s slot and roll it up.
Adjusting slide topper awnings is fairly simple.
You do not want to get it too tight and it takes only a few extra minutes to roll the awning up without replacing the screws.
Usually takes 2 people.
